AT91RM9200
|
 Supported by the Crossware ARM Development Suite
Graphical Code Creation Wizards:
- Burst flash controller
- External bus interface
- FIQ
- IRQ0...IRQ6
- Power management controller (PMC)
- SDRAM controller (SDRAMC)
- Serial peripheral interface (SPI)
- Synchronous serial controllers (SSC0, SSC1 and SSC2)
- Static memory controller (SMC)
- System interrupt
- Timer/counters
- Two wire interface (TWI)
- Universal synchronous/asynchronous receiver/transmitters (USART0, USART1, UART2 and USART3)
- USB device port (UDP)
Context menu Code Creation Wizards:
- Advanced interrupt controller (AIC)
- Burst flash controller
- Debug unit
- External bus interface
- Memory controller
- Multimedia card interfaces (MMC0 and MMC1)
- Ports (PIOA, PIOB, PIOC and PIOD)
- Power management controller (PMC)
- Real time clock
- SDRAM controllers (SDRAMC)
- Static memory controller (SMC)
- Serial peripheral interface (SPI)
- Synchronous serial controllers (SSC0, SSC1 and SSC2)
- System timer
- Timer/counters
- Two wire interface (TWI)
- Universal synchronous/asynchronous receiver/transmitters (USART0, USART1, UART2 and USART3)
- USB device port (UDP)
Source level ARM instruction set simulation
Simulation of the memory management unit (MMU) and fast context switch extension (FCSE)
Peripheral simulation:
- PLL
- Advanced interrupt controller
- Ports
- Timer/counters
- Universal synchronous/asynchronous receiver/transmitters (USART0, USART1, UART2 and USART3)
Source level on-chip debugging with Jaguar USB JTAG interface
- Debugging with the memory management unit (MMU) and fast context switch extension (FCSE) enabled
|
